Selective Soldering Pallets
Selective Soldering Pallets, Reflow Pallets, Adjustable Pallets and Component Holddown Pallets are produced from Durostone material, which is flux resistant and can operate till 380 degrees. 3D design is also prepared by ATERON experienced personnel for optimum results. We can offer several type of material.
Reflow Pallets
We recommend to use Reflow Pallets of Durostone Material, for your different PCB shapes, thin PCB material use to avoid warpages on your assembled board. You will be able to work effective with every kind of shapes and material thicknesses.
The following are the general data files required for fixture development. Products are processed differently. Supplying us with all of this data will ensure that we have what is needed for your application.
Top & Bottom Side Silkscreen
Top & Bottom Side Paste
Top & Bottom Side Mask
Fabrication Drawing
Drill Fab Layer
Other Requirements:
Height of components on the solder side of the PCB
Height of components requiring hold downs
Identify any components which overhang the board and whether they seat flush to the top of the PCB or receed to a certain depth
Selective Soldering Pallets
Enables wave soldering of PTH components to Double Sided, mixed technology assemblies.
Selective soldering pallets allow the soldering of plated through hole (PTH) components to dual sided mixed technology assemblies while protecting solder side surface mount devices (SMD). The solder apertures are the areas that will expose your PTH leads to solder. These apertures have a sealing wall, much like a gasket, that presses against the circuit board to control the area that is exposed to the solder. Machined into the fixture are a series of pockets cut into the bottom surface that are engineered to promote solder flow to all the PTH areas.
Required general data files:
Top & Bottom Side Silkscreen
Top & Bottom Side Paste
Top & Bottom Side Mask
Fabrication Drawing
Drill Fab Layer
Other Requirements:
Height of components on the solder side of the PCB
Height of components requiring hold downs
Identify any components which overhang the board and whether they seat flush to the top of the PCB or receed to a certain depth